13
Place the spring washer (
8
) on the arbour and insert the screw
(
9
) and tighten by hand.
Turn the disc slowly until the stop hole of the V-belt pulley is
visible in the cutting arm cover (
10
).
Insert the Allen key (
2
) as far as it will go. The shaft is now
blocked.
Tighten the screw with the combination wrench (
1
)
NOTE:
Tighten the screw
Þ
rmly (30 ± 2 Nm), as otherwise
the cutting wheel may slip during cutting.
Mounting the cutting disc
Inspect the disc for damage.
See SAFETY INSTRUCTIONS, Page 6.
Unscrew screw (
9
) and remove the spring washer (
8
).
Place the cutting disc (
5
) on the arbour (
7
).
Hinweis:
The arbor hole of the cutting disc must be an exact
Þ
t with the arbor or shaft. If the arbor hole is larger, it must be
Þ
tted with an adapter ring (*).
Make sure the cutting disc is installed so it turns in the right
direction, if a direction is marked on the disc.
PUTTING INTO OPERATION
CAUTION:
Always turn off the engine and pull off the spark plug cap
before doing any work on the Power Cut! Always wear
protective gloves!
CAUTION:
Start the Power Cut only after complete assembly and
inspection.
Sequence
For the the following work, use the assembly tools included
with delivery:
1. 13/19 AF combination wrench
2. Allen key
3. Carburetor adjustment screwdriver
4. Adapter ring (not in the general delivery inventory)
Place the Power Cut on a stable surface and carry out the fol-
lowing assembly steps:
Only for models PC-8114 and 8116
No air
Þ
lter is installed!
Before operation, insert an oiled foam
Þ
lter (pre-
Þ
lter), as shown in the adja-
cent illustration! To do this, take off the
Þ
lter cover (see the chapter on Cleaning /
changing the air
Þ
lter).
