![background image](http://html1.mh-extra.com/html/dolmar/at-3724-u/at-3724-u_instruction-manual_2517232018.webp)
18
As shown in the figure, put the shoulder harness on your
left shoulder by putting your head and right arm through it
and keep the tool on your right side while always keeping
the barrier in front of your body.
(Fig. 36)
Attachment of shoulder harness (Fig. 37)
After putting the shoulder harness on it can be attached to
the tool by connecting the buckles provided on both the
tool hook and the harness. Be sure that the buckles click
and lock completely in place.
Detachment (Fig. 38)
The buckle is provided with a means of quick release
which can be accomplished by simply squeezing the
sides and the buckle.
WARNING:
•
Be extremely careful to maintain control of the tool
at all times. Do not allow the tool to be deflected
toward you or anyone in the work vicinity.
Failure to
keep control of the tool could result in serious injury to
the bystander and the operator.
MAINTENANCE
WARNING:
•
Always be sure that the tool is switched off and
battery cartridge is removed before attempting to
perform inspection or maintenance on the tool.
Failure to switch off and remove the battery cartridge
may result in serious personal injury from accidental
start-up.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or the like.
Discoloration, deformation or cracks may result.
Supply of grease to gear case (Fig. 39)
Supply grease (Shell Alvania 2 or equivalent) to the gear
case. Remove the hex bolt and then put grease through
the grease hole every 30 hours. (Genuine Dolmar grease
may be purchased from your Dolmar dealer.)
Replacing the nylon cord
WARNING:
•
Make sure that the cover of the nylon cutting head
is secured to the housing properly as described
below.
Failure to properly secure the cover may cause
the nylon cutting head to fly apart resulting in serious
personal injury.
Take off cover from housing, pressing two latches which
are slotted section oppositely on side of housing.
(Fig. 40)
Cut a nylon line in 3-6 m. Fold the cutting line in two
halves, leave one of half longer 80-100 mm than another.
(Fig. 41)
Hook the middle of the new nylon cord to the notch
located at the center of the spool between the 2 channels
provided for the nylon cord.
Wind both ends firmly around the spool in the direction
marked on the head for left hand direction indicated by
LH.
(Fig. 42)
Wind all but about 100 mm of the cords, leaving the ends
temporarily hooked through a notch on the side of the
spool.
(Fig. 43)
Mount the spool on the cover so that the grooves and
protrusions on the spool match up with those on the
cover. Now, unhook the ends of the cord from their
temporary position and feed the cords through the eyelets
to come out of the cover.
(Fig. 44)
Align the protrusion on the underside of the cover with the
slots of the eyelets. Then push the cover firmly onto the
housing to secure it. Make sure the latches fully spread in
the cover.
(Fig. 45)
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by DOLMAR Authorized Service Centers,
always using DOLMAR replacement parts.
TROUBLE SHOOTING
Before asking for repairs, conduct your own inspection
first. If you find a problem that is not explained in the
manual, do not attempt to dismantle the tool. Instead, ask
Dolmar Authorized Service Centers, always using Dolmar
replacement parts for repairs.