The button turns blue to indicate it is on.
2. From the
Settings
menu, select
Speaker Configuration
.
3. From the
Stereo Monitoring
drop-down list, select
LtRt
or
LoRo
.
4. Click
Apply
or
OK
.
5. From the target device list, select
Stereo
.
Figure 9: Target device list
The audio on the local output is the 5.1 channel configuration downmixed to stereo using
the Lt/Rt or Lo/Ro method. It is not the stereo configuration set up and visible in the
DP590 main window.
6. Optional: To turn off the 5.1-channel downmix monitoring, perform one of these steps:
a) In the main window, click on the
STB Mode
button.
The button turns gray to indicate it is off.
b) In the Speaker Configuration window, from the
Stereo Monitoring
drop-down list,
select
Direct
. (This is the default setting.)
4.11 Monitoring dynamic range control
You can check the influence of dynamic range control on the stereo and 5.1 channel
configurations.
About this task
This function allows you to listen to a stereo or 5.1 channel local output with Line or RF mode
compression. These settings are not applied to the presentation metadata and are intended
only to simulate the influence of compression on the end device output.
Both compression modes use a Film Light profile.
Procedure
1. To turn on compression, in the main window, click on the
STB Mode
button.
The button turns blue to indicate it is on.
2. From the
Settings
menu, select
Speaker Configuration
.
3. From the
Compression Mode
drop-down list, select
Line
or
RF
.
4. Click
Apply
or
OK
.
The selected compression mode is applied to the local output.
5. Optional: To turn off compression, perform one of these steps:
a) In the main window, click on the
STB Mode
button.
The button turns gray to indicate it is off.
Dolby Object Authoring Tool DP590 operation
Dolby Object Authoring Tool DP590 quick-start guide
Preliminary 10 May 2017
25
