9
Programming (matching) of the remote controller and the receiver
Every remote controller has its own RF operational code. Programming of the remote controller with
the receiver (collar) will be take place during the first use of the
Dogtrace d–control
set or with a new
remote controller or a receiver (when former or latter is lost). This operation will enable you to match
your remote controller with the delivered receiver (collar).
Turn on your transmitter.
Touch the lower part of your remote controller to the target on your receiver (see the photo on
page 8). The green LED will be permanently lit and after some 6 seconds, it will switch to the pro-
gramming mode, indicated by permanent flashing of the red LED.
Now take your transmitter away and press down the sound signal button
on your remote
controller. The codes will be matched in this step and your receiver will produce a sound signal.
IMPORTANT:
Before programming is started (before using your receiver for the first time or before
code rewriting) make sure that no one else uses his/her d–control or another product made by
Dogtrace in your neighbourhood – your receiver might randomly receive the code from another
remote controller and set itself to it. If this happens, program your receiver once again, using your
remote controller.
