DOGA SCOUT II, Инструкция по эксплуатации

Страница: 7 / 40

Instructions manual / Electric screwdrivers
7
1) The power is supplied from XS-38D or XS-40D controller to Scout through RJ-11 "A" screwdriver port.
The screwdriver port "A" works for power feeding from the connected controller XS-38D or XS-40D additionally.
If the screwdriver port "A" is empty (not used), then external power (24VDC, 1A) is required.
2) Scout II have 4 screwdriver ports for direct connecting of XS-38D and XS -40D.
Also one extra screwdriver can be connected through 25P I/O.
3) Cycle can be started by the signal from PLC, sensor or other equipment.
Also Scout gives the cycle complete signal to PLC or other equipment, too through the 25P I/O port.
4) The numeric LED shows the number of screws which should be fastened for a cycle.
5) Power Input (24VDC,1A) is required when the Hybrid screwdriver is connected.
Don't connect both XS-38D (or XS-40D) and HDC controller together to Scout II.
6) Fastening results are displayed by NG or OK for every fastening.
In order to use NG/OK judgment, the different parameter settings can be saved on the program no. from 1 to 8.
7) Parameter setting is also possible on Scout Manager (pc software).
It transmits the settings to Scout II.
The settings on programs can be saved in .csv format file.
4. Caution
1) The screw counter SCOUT II should be used with XS-38D or XS-40D controller only.
Never use the screw counter with any other tools not specified by the manufacturer.
It can be dangerous by the electrical shock.
2) Be careful of right connecting cable between the screwdriver controller and Scout II.
3) Never use non specified cable by the manufacturer.
4) Don't connect both XS-38D (or XS-40D) and HDC controller together to Scout II.
5) Do not use the screw counter near fire and magnetic environment.