DOGA GX150, Инструкция по эксплуатации

Страница: 10 / 16

Instructions manual / GX Screwdrivers
10
10.3 Angle control & Auto reverse ( GXT____ )
Model : GXT150, GXT220, GXT450
One triggering by the lever can make 3 step operation sequence in a cycle
■
Start, Stop and Direction in a cycle
Step 1
→
2
→
3
Sequence first RUN stop HOLD reverse RUN
Rotating
direction
Clockwise or
Counterclockwise by F/R
switch
Reverse
Activating
Screwdriver runs to the
target angle and stop. It
always stops at the set
torque, even it does not
reach the target angle.
Stop and hold for set time
Rotate reverse until
releasing the lever or
stop at the target torque
Time setting 0 - 5 sec / 30 steps 0 - 5 sec / 12 steps x
- Screwdriver stops Immediately when the lever is released in any sequence.
- Sliding F/R switch works for
■
Operating (Work) mode
①
Rotating direction (FOR-REV)
■
PROGRAM mode
①
First run angle (Increase / Decrease) together with "First Run(Speed)" button
②
Time (Increase / Decrease) together with "Stop(Reverse)" button
③
Rotation speed (Increase / Decrease) together with "Speed(First Run)" button
④
Reverse run angle (Increase / Decrease) together with "Reverse(Stop)" button