Instructions manual
/ BTP
8
Forward/ Reverse Rotation Switch Operation
To prevent damage, do not press Forward/Reverse button
until the anvil comes a complete stop.
Forward Rotation Operation
The tool is in forward operation if the blue light is not on.
Reverse Rotation Operation
By long press on the F/R switch, users are able to choose
the mode of Reverse operation, either automatic or
manual.
Mode 1: Automatic – Tool returns to Forward operation
automatically after reverse operation.
Mode 2: Manual – Tool needs to be adjusted manually to
return to Forward operation after reverse operation.
How to adjust: Long press on the F/R switch and release it
as seeing the flashing blue light is on. The mode is
transformed successfully
LED Indicator
When the arrow mark is blue, it means the tool is in
the reverse operation.
A green light tells the operator that the preset torque
isreached and the tightening is OK.
A flashing yellow light and five short “beep
@
sounds
give an early warning when it is time for recharging.
Red light and one long “Beep” sound
tell the user :
1. The preset torque is not reached
and the screwing fastener must be
performed again.
2. The screwing fastener has been
tightened repeatedly.
A yellow light and one long “beep
@
sound mean a battery lock that
indicates the tool can’t work and MUST
change the battery pack immediately.
Steps for Torque Adjustment
1. Lift the torque adjustment over. Take the
torque adjust tool and insert it to the quick
change holder and turn until the adjust hole
shows up.
Note:
To avoid danger during the adjustment
process, the battery pack must be removed
before adjusting the torque.
2. Use the torque adjust tool to turn clockwise to
increase torque and turn counterclockwise to
decrease torque.
