Instructions manual
/ BTP
7
4. ASSEMBLY
Check for damage to the tool; parts or accessories which
may have occurred during transport. Take the time to
thoroughly read and understand this manual prior to
operation.
This tool kit contains:
- 1 18V cordless Shut off Screwdriver
- 1 torque adjust tool
- 1 suspension bail
- 4 marking color ring
- 1 instruction manual
Attaching or Removing Battery Pack
1. To connect battery, line up the tracks and attach the
battery pack. Slide toward the battery pack until it locks
into position with a click.
2. To remove the battery pack, press the red button on the
top of the battery pack and release the battery pack.
5. OPERATIONS
This product had been carefully inspected prior to
leaving the factory. It should provide you with years
of satisfying service under normal operating
conditions. Do not, however, force the tool to
perform outside its design parameters. Such usage
will void the warranty.
WARNING!
Read the manual instruction before
operating the tool. Always wear safety glasses or
face-shields when operating this product. Failure
to do so can result in dust, shavings or loose
particles being thrown into your eyes.
1. Slide battery into the bottom of the housing
handle until a click sound occurs. Do not force
battery as it should slide easily into place with
nominal force. Any difficulty doing so would
indicate an incorrect alignment.
2. Select a proper size drive bit and insert into the
quick change holder.
3. Depress the trigger to engage the LED light and
the tool starts to work. Check the torque on the
digital tester to see if the desired torque
reached. If not, adjust the torque to either
tighten or loosen the spring. See he Steps for
Torque adjustment on page 7.
4. Make sure the tighten torque of the bolts or
screws before work. It may vary due to different
material you tighten. When the torque is reach,
the tool will shut off automatically.
