20
It is important to keep the device clean. Never use volatile substances eg.: thinner, gasoline
or other cleaners. To clean your d-control use a soft, damp cloth and neutral detergent if
necessary.
The transmitter and the receiver (collar) is water proof only on condition of the good
state of the seal. We recommend you to replace the rubber seal, which is placed under
the cover of the battery compartment of the transmitter and the receiver, once a year.
Clean the rubber seal and make sure that the rubber seal is correctly seated in its groove
every time you change the batteries; tighten the screws using adequate power.
If the device is not used for a longer time, take out the batteries from the battery
compartment.
touch with the screw and tighten them (see
picture).
Turn ON the transmitter and the receiver.
Select stimulation function button.
The test discharge lamp will increase a light
intensity when increasing stimulation level.
6.
If the problem still persists, contact the dealer.
Maintenance
Note:
When is the level set to 00 there is no
stimulation. When you use test discharge lamp
the stimulation impulse is weaker than without
discharge lamp.
Picture showing test lamp attachment
