12
Programming (pairing) of the transmitter and the receiver
Each transmitter has its own RF operational code. The pairing needs to be done to make
the receiver and transmitter operate together. When you receive a new set the pairing is
done by manufacturer. The pairing is done, when you need to use different transmitter
or receiver (for example when bought a new one).
The transmitter is made for training of two dogs, so you can pair it with two receivers. Use
the buttons
/
to choose the right dog.
Pairing of the button
with the first receiver
1.
Turn ON your transmitter.
2.
The receiver has to be turned OFF.
3.
Press the button
for the first receiver choice.
4.
Move the lower part of the transmitter to the target on your receiver (see the Fig. on
page 11) and hold in position so the green LED is steadily lit. After approximately
5 seconds it will switch to the pairing /programming mode, indicated by flashing of
the red and green LED at the same time (4x).
5.
Then take your transmitter away from the receiver and press down the audible beep
tone button
on your transmitter. If you hear the beep tone the pairing has been
successful.
Pairing of the button
with the second receiver
Press the button
for the second receiver choice and follow the steps as for the first
receiver above (this can be followed when you use d-control 600, 1000 or 1600 with a
new purchased receiver or when you purchased d-control 602, 1002 or 1602).
IMPORTANT:
Before programming is started make sure that no one else uses his/her
d–control in your neighbourhood. Your receiver could randomly receive the code
from another transmitter and get paired with it. If this happens, program your receiver
once again, using your transmitter.
