DOEPFER d3m, Руководство пользователя

Страница: 11 / 12

d3m Page 11 User's Guide V1.2
Programming Mode
The programming mode is used to adjust several basic parameters of the d3m . This mode is
called up when d3m is turned on while one of the 22 buttons is held down during power on.
Even in this mode all LEDs light up after power on and go out from left to right. After that all
LEDs with exception of number 1 light up again to indicate the programming mode.
The bank buttons are used to select the parameter that has to be changed. As soon as one
of the bank buttons is operated all LEDs turn off and only the LED of the button that has
been operated lights up. After that the number buttons are used to adjust the value for the
selected parameter.
The following table shows the parameters that are assigned to the bank buttons (first and
second column) and the values that can be adjusted with the number buttons (third and
fourth column):
Bank Parameter Number Value/function of the parameters
1 Midi channel 1-12 Midi channel 1-12
1 B4
2 EVB3
2 Selected device in play mode
3 Remote
1 Expression (Controller #11) 3 Function of the foot control
2 Volume (Controller #7)
1 Leslie Slow/Fast (toggle)
2 Leslie On/Off (toggle)
Foot control
operated Foot control
released
3 Leslie Fast Slow
4 Leslie Slow Fast
5 Leslie On Off
6 Leslie Off On
7 Sustain On Off
8 Sustain Off On
9 Vibrato On/Off (toggle)
10 Vibrato On Off
4 Function of the foot switch
11 Vibrato Off On
1 dynamic (velocity activated)
2 fixed velocity value 20
3 fixed velocity value 30
.... ...
11 fixed velocity value 110
5 Velocity mode
12 fixed velocity value 127
For some of the switch functions of the foot control (Leslie Slow/Fast, Leslie On/Off, Vibrato
On/Off) two different switching modes are available:
•
Toggle mode: in this mode the state changes with each operation of the foot switch, e.g.
slow
→ → → →
fast
→ → → →
slow
→ → → →
fast and so on.
•
Momentary mode: e.g. foot control operated = slow, foot control released = fast
As soon as a parameter has been changed by operating the corresponding bank and
number buttons the new value is stored into the non-volatile memory of the d3m. As soon as
all parameters are set to the desired values the d3m has to be turned off by removing the
power supply. Please wait about 10 seconds and then turn on again the d3m without
operating one of the buttons. Then the d3m enters the normal play mode as described on
page 8 and uses the new parameters that have been adjusted in the programming mode .
(e.g. another Midi channel or play mode or foot controller/switch function).
.