Dodge DURANGO 2020, Руководство пользователя

Страница: 263 / 452

IN CASE OF EMERGENCY 261
(Continued)
6. Disconnect the electrical connector and
then connect the replacement bulb.
7. Install the bulb and connector assembly
into the headlamp housing and rotate
clockwise to lock in place.
8. Install the bulb access cap in the headlamp
housing and rotate clockwise to lock it in
place.
9. Install the access cap in the wheel liner and
rotate clockwise to lock it in place.
Front Turn Signal
1. Open the hood.
2. Turn the turn signal bulb a quarter turn
counterclockwise to remove from housing.
3. Disconnect the electrical connector and
replace the bulb.
Front Fog Lamps
1. Reach through the cutout in the splash
shield and rotate the bulb’s electrical
connector a quarter turn counterclockwise
and remove it from the fog lamp housing.
2. Remove the bulb from the connector and
install the replacement bulb.
3. Install the bulb and connector assembly
into the fog lamp housing and rotate the
connector a quarter turn clockwise to lock it
in place.
Rear Tail, Stop And Turn Signal Lamps
The rear tail, stop, and turn signal lamps are
LED. See an authorized dealer for replacement.
Rear Liftgate Mounted Back-up Lamps
1. Raise the liftgate.
2. Use a fiber stick or flat blade screw driver to
pry the lower trim from the liftgate.
3. Back-up lamps are now visible. Rotate
socket(s) counterclockwise.
4. Remove/replace bulb(s).
5. Reinstall the socket(s).
6. Reverse process to reinstall the liftgate
trim.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with an oily
surface, clean the bulb with rubbing alcohol.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with an oily
surface, clean the bulb with rubbing alcohol.
CAUTION!

Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any
oily surface, clean the bulb with rubbing
alcohol.

Always use the correct bulb size and type
for replacement. An incorrect bulb size or
type may overheat and cause damage to
the lamp, the socket or the lamp wiring.
CAUTION! (Continued)
6
20_WD_OM_EN_USC_t.book Page 261