Dodge Challenger SRT 392 2015, Руководство по эксплуатации

Страница: 103 / 658

Changing FCW Status
The FCW Sensitivity Settings are program-
mable through the Uconnect® System. Refer to
“Uconnect® Settings” in “Understanding Your
Instrument Panel” for further information.
The default status of FCW is the “Far” setting is
the “On” setting, this allows the system to warn
you of a possible collision with the vehicle in
front of you when you are farther away. This
gives you the most reaction time to avoid a
possible collision.
Changing the FCW status to the “Near” setting,
allows the system to warn you of a possible
collision with the vehicle in front of you when
you are much closer. This setting provides less
reaction time than the “Far” setting, which al-
lows for a more dynamic driving experience.
NOTE:
•
The system will retain the last setting
selected by the driver after ignition shut
down.
•
FCW may not react to irrelevant objects
such as overhead objects, ground reflec-
tions, objects not in the path of the car,
stationary objects that are far away, on-
coming traffic, or leading vehicles with
the same or higher rate of speed.
•
FCW will be disabled like ACC, with the
unavailable screens.
Service FCW Warning
If the system turns off, and the DID displays:
•
ACC/FCW Unavailable Service Required
•
Cruise/FCW Unavailable Service Required
This indicates there is an internal system fault.
Although the vehicle is still drivable under nor-
mal conditions, have the system checked by an
authorized dealer.
PARKSENSE® REAR PARK
ASSIST — IF EQUIPPED
The ParkSense® Rear Park Assist system pro-
vides visual and audible indications of the dis-
tance between the rear fascia and a detected
obstacle when backing up, e.g. during a parking
maneuver. Refer to “ParkSense® System Us-
age Precautions” in this section for limitations of
this system and recommendations.
ParkSense® will retain the last system state
(enabled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
ParkSense® can be active only when the shift
lever is in REVERSE. If ParkSense® is enabled
at this shift lever position, the system will remain
active until the vehicle speed is increased to
approximately 7 mph (11 km/h) or above. The
system will become active again if the vehicle
speed is decreased to speeds less than ap-
proximately 6 mph (9 km/h).
ParkSense® Sensors
The four ParkSense® sensors, located in the
rear fascia/bumper, monitor the area behind the
vehicle that is within the sensors’ field of view.
The sensors can detect obstacles from approxi-
mately 12 in (30 cm) up to 79 in (200 cm) from
the rear fascia/bumper in the horizontal direc-
tion, depending on the location, type and orien-
tation of the obstacle.
ParkSense® Warning Display
The ParkSense® Warning screen will only be
displayed if Sound and Display is selected from
100