signal processing
7) VOLUME CONTROLLER INPUT
- This 1/4" connector is used to
connect most volume pedals or 0/+5v controller pedals to the
Acoustic One for real-time control of volume functions.
8) AC POWER INPUT
- Connect the supplied AC power adapter
to this jack. Use only the adapter supplied with the Acoustic
One. Use of any other adapter may damage the unit.
9) POWER CORD STRAIN RELIEF
- This clip prevents the AC
power cord from being accidentally pulled out.
Hooking Up
DO NOT APPLY POWER TO THE ACOUSTIC ONE UNTIL INSTRUCTED.
1)
STEREO:
Connect the Left and Right outputs to a pair of guitar
amplifiers or the inputs of a mixing console. If you're using guitar
amps, set the tone controls flat (no boost or cut) and balance the
levels between them. If you're using a console, pan the Acoustic
One input channels hard left and right and turn down the high
frequency EQ for best results.
MONO:
Connect the Left output to a guitar amplifier or input of a
mixing console.
2)
Connect your instrument to the input of the Acoustic One.
3)
OPTIONAL:
Connect a volume type or 0/+5v controller pedal to
the Controller input of the Acoustic One. Make sure the pedal is
connected before you apply power to the Acoustic One.
4)
Power up the Acoustic One by connecting the supplied AC
adapter between the Acoustic One and a power outlet.
5)
Play your instrument and watch the Clip LED on the Acoustic One
carefully as you set the Input knob. Turn up the input level until
the Clip LED begins to light and back off the knob slightly. When
the Input knob is set properly, the Clip LED should not flicker on
the loudest passages. It is important to remember that In
bypass/tuner mode, the clip LED will not light.
6)
Set the output level as desired.
7
Acoustic One owner's manual
