START WITH COMPONENTS
AROUND POWER CONNECTOR:
D4, D5
- 1N5819HW diodes (SOD123)
L1, L2
- filter beads (0603, if you can't get them substitute with 10R resistors)
IC1
- LM1117DT-5.0 (TO252, 5V voltage ragulator)
C9, C10
- 47uF/35V (PANASONIC D)
C8
- 22uF/25V (PANASONIC C)
POWER CONNECTOR
- 2x5 eurorack power connector, preferably shrouded
D5
AND
D6
IS MISSING FROM THE SILKSCREEN ON YELLOW PCBS,
THEIR ORIENTATION IS SHOWN BELOW
STEP 1
PAGE: 01
CHECK VOLTAGES!
Connect power cable, the red stripe of the ribbon cable must be oriented
on the same side as shown on PCB. Power up the module and check voltages:
+12V
@
IC4 pin 7,
-12V
@
IC4 pin 4,
5V
@
IC3 pin 1
