DNA ACD3, Руководство пользователя, Страница: 10 / 12

EN-10
Troubleshooting
The device will not switch on
The ignition is not switched on
• Switch the ignition on by turning the key. One of the fuses is defective.
• Replace the fuse.
The CD will not load or eject
A CD is already inserted into the car radio.
• Remove the CD.
The CD has been inserted the wrong way up.
• Insert the CD with the inscripted side up.
The CD is dirty or defective.
• Clean the CD or insert a different CD.
The temperature in the vehicle is too high.
• Wait until the surrounding temperature has normalized.
Condensation on the laser lens
• Switch the car radio off for a few hours and then try it again.
No sound
The volume is set to minimum.
• Increase the volume.
The cables are not connected correctly.
• Check the cable connections.
Function buttons are not functioning
There is a malfunction with the device.
• Press the RESET button.
The face plate is not correctly installed.
• Check to see that the face plate is installed correctly.
The CD jumps
The mounting angle exceeds 30°.
• Correct the mounting angle.
The CD is very dirty or defective.
• Clean the CD or insert a different CD.
Failure with burnt CDs
Check the burnt CD in another playback device.
The radio and/or the automatic station memory is not functioning
The antenna cable is not connected correctly.
• Check the antenna cable for correct connection.
The station signals are too weak.
• Set the station manually.
Station memory is not functioning
The connection 6 in the ISO block A (Permanent positive) is not connected correctly.
• Check the cable connections.
For this consult the chapter “Connections”.
Cleaning
Clean the housing exclusively with a soft damp cloth and a mild detergent. Ensure that moisture cannot
permeate into the device during cleaning!
Warning!
Moisture penetrating into the device creates the risk of electric shock! Besides which, the sdevice could
become irreparably damaged!