DMS FR Series, Руководство пользователя

Страница: 10 / 14

10
Section VI: System Maintenance
A. Base Roll Assembly
1. Daily
a. Inspect base roll for damage or excessive wear. Clean any foil adhesive build-up with solvent on a soft cloth.
b. Inspect die drive gear for proper lubrication and excessive wear.
B. Die Shaft Assembly
1. Daily
a. Inspect the die mounting screws for loose connections and tighten if necessary.
b. Inspect drive gears for excessive or abnormal wear.
2. Weekly
a. Inspect shaft bushings for excessive wear or cracks due to shock. The shaft assembly needs to be returned to
DMS to have new bushings installed, as special tools and fixtures are required for this procedure to ensure
proper operation.
b. Inspect connections for loose or damaged parts.
c. Inspect lateral register assembly for proper fit in the press.
d. Inspect operator side bearing block for oil once a month, block takes 1 oz of Mobile # 1 oil , do not add more
than the 1 oz. required limit for the block.
C. Die Assist Assembly
1. Daily
a. Inspect cam followers for proper lubrication and excessive wear.
b. Add high temperature grease (+550
° F) to cam followers after every 4-6 hours of run time. Use ONLY DuPont
Krytox® GPL-407 high temperature grease. Failure to do so will void warranty, damage cam followers, and
degrade performance. DMS includes one cartridge in the accessory box.
c. Check infrared thermocouple sensor for proper position or possible damage.
d. Make sure infrared thermocouple sensor is clean and free of dirt and grease.
D. Control Unit, Hoses and Cables
1. Weekly
a. Inspect hoses and cables for damage.
b. Make sure all connections are secured and locked.