X1 SERIES ELEVATOR CONTROLLER INSTALLATION & PROGRAMMING GUIDE | DIGITAL MONITORING PRODUCTS
4
Set the Address
The X1 Elevator Control Module PCB has a 1 through 9 addressable rotary dial that is
factory defaulted to 1� Additional elevator control modules need to be addressed in
sequence�
Wire the X1 Elevator Control Module PCB to the Expansion Module
Use the included 4-position harness
to connect the top connector on the
third elevator control module to the
bottom connector on the second
elevator control module�
0 1
2
3
4
5
6
7
8
9
First X1 Elevator Module
X1 Elevator Controller
12 V Battery
+ -
-
+
0 1
2
3
4
5
6
7
8
9
Second X1 Elevator Module
0 1
2
3
4
5
6
7
8
9
Third X1 Elevator Module
X1 Elevator Controller
X1 Elevator Expansion
Optional X1 Elevator Controller PCB Only
If not installing additional elevator
modules, skip to Step 2
Connect a
Card Reader
�
Mount the Module
The metal enclosure for the X1 Elevator
Expansion Module (X1-ELEV-EXP)
comes with mounting holes for
two additional X1 Elevator Module
PCBs (X1-ELEV-PCB)� To mount the
additional PCB, use the provided
standoffs and screw the PCB onto the 3
mounting holes�
0 1
2
3
4
5
6
7
8
9
Second X1 Elevator Module
0 1
2
3
4
5
6
7
8
9
Third X1 Elevator Module
Standoffs (3)
X1 Elevator Expansion
Screws (3)
c
0 1
2
3
4
5
6
7
8
9
Second X1 Elevator Module
0 1
2
3
4
5
6
7
8
9
Third X1 Elevator Module
Standoffs (3)
X1 Elevator Expansion
Screws (3)
