Wiring Block to Keypad Connections
As needed, refer to the specific keypad installation guide. Plug the terminal end of the 4 ft. wire harness onto the
4-pin header in the back of the keypad through the back of the 699 Deskstand.
RED YEL GRN BLK
7 8 9 10
XT30/XT50
XR100/XR500
Panel
Terminals 7-10
Thin Keypad on
699 Deskstand
B
K
R
D
Y
L
G
R
B
L
O
R
S
L
B
R
WH
Black
Yellow
Red
Green
Mounting
holes
(2 places)
Wiring
Block
Modular
Receptacle
Figure 4: Panel to Keypad Wiring
Keypad Rear Connections
Figure 5 shows the 699 Backplate rear view with the 4-wire connector plugged into the 4-pin header. Run a tie wrap
through the back or base of the 699 Deskstand. Roll the excess length of the 4 ft. Wire Harness into a loop and use
the tie wrap to hold it in place.
Wire Harness with wire
tie strain relief in place.
4-wire
connector
plugged
into keypad
4-pin header.
Deskstand Rear View
RED
To Wiring Block
Optional 4-wire
connector locations
depending on the
specific keypad installed.
Optional Wire
Harness wire
tie strain relief
mounting hole.
4 ft. Wire Harness wire tie strain relief
mounting holes located in Deskstand base.
Figure 5: 699 Backplate Rear View
699 Installation Guide
Digital Monitoring Products
3
