©COPYRIGHT 2018 DANIELS MANUFACTURING CORPORATION
WWW.DMCTOOLS.COM
(407) 855-6161
PATENT #7,243,429
10
TSK8000 MANUAL
TSK8000-M
REV E
Installing Dies
Important Note:
Die halves and tool arms are marked “A” and “B”. Operator must ensure that
the “A” and “B” die halves are placed on the corresponding tool arms.
1. Follow the previous steps to lock the tool arms in the open position.
2. Press the die release button on one tool arm, exposing the die mounting post (A). Place
the “A” die half onto the die mounting post of the tool arm marked “A”, repeat for the “B”
die half (B). Check to make sure the die half is fully engaged with the die mounting post.
Release the die release button, and check to make sure the die half is fully inserted into
the tool arm (C). Repeat this procedure for the other tool arm (D).
Note:
When changing die sets, always verify that the die part number that appears on
both die halves are the same number. Do not mix die part numbers.
3. Follow the instructions below to unlock the tool arms, and bring the die halves togeth-
er. The die halves must be flush with one another, displaying no signs of misalignment
(D). If misalignment or a gap between the die halves is observed, verify the part number
is the same on both die halves, inspect to see if any cable remnants or debris is lodged
between the die halves. If misalignment is still observed, remove both die halves and
reassemble the die set into the tool.
C
5.2
B
D
A