HPU13M Battery-powered Pump
HPU13M-DS REV. A ©2014 DANIELS MANUFACTURING CORP.
ALL RIGHTS RESERVED
526 Thorpe Rd. • Orlando, FL 32824 USA • 407-855-6161
www.dmctools.com
8
Operation
Inspect pump, hoses, couplers, and fittings for wear or
damage. Replace worn, damaged, or missing components
with DMC replacement parts. Worn or damaged compo-
nents can fail, resulting in injury.
Failure to observe this warning could result in severe injury
or death.
Electric shock hazard:
This tool is not insulated. When using
this unit near energized electrical
lines, use proper personal protective
equipment.
Failure to observe this warning could
result in severe injury or death.
Wear eye protection when operating or
servicing this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris or hydraulic oil.
Cutting hazard:
• Remove battery before changing dies,
adapters, or jaws.
• Keep hands away from the head when
in operation.
Failure to observe these warnings could
result in severe injury or death.
Skin injection hazard:
• Do not use hands to check for leaks.
• Depressurize hydraulic system before
servicing or disconnecting the hose.
High pressure oil easily punctures skin,
causing serious injury, gangrene, or death.
If injured, seek medical help immediately
to remove oil.
Electric shock hazard: The owner of this tool must be
certain that all users of this tool are trained in the applicable
safety codes and standards as well as in the safe use of this
tool and its accessories.
Failure to observe this warning could result in severe injury
or death.
• Do not use this tool for continuous use. After
100 cycles, allow the tool to cool for 15 minutes.
• Do not secure this tool in a vise. This tool is designed
for hand-held operation.
• Use this tool for the manufacturer’s intended purpose
only.
Failure to observe these precautions may result in injury
or property damage.
Procedure for depressurizing the hydraulic system:
1. Disconnect the pump from the power source.
2. Press down on the manual release shaft and allow the
ram to retract fully.
3. Disconnect the hose slowly to release any trapped
pressure.
Charging the Battery
Read the instructions supplied with the battery charger.
