Rev. 1.7 (May 2018) 3 © DLP Design, Inc.
3.2 LP8C SPECIFIC COMMANDS
To select one of the 8 external antennas on the DLP-RFID-LP8C you must send the correct command
packet (Ex: 010900030422F00000). To send this packet using the TI GUI, first make the connection to
the DLP-RFID-LP8C, and then click on the Test tab. Enter a command packet as shown below and click
on Send Raw. The LED associated with the antenna channel selected will light and successive tag reads
will use that channel.
LP8C Specific commands:
Commands to activate 1 of the 8 Antenna Channels:
1. 010900030422F00000
2. 010900030423F00000
3. 010900030424F00000
4. 010900030425F00000
5. 010900030426F00000
6. 010900030427F00000
7. 010900030428F00000
8. 010900030429F00000
Read Opto-isolated inputs:
010900030435F00000
Write opto-isolated output 1 high:
010900030430F00000
Write opto-isolated output 1 low:
010900030431F00000
Write opto-isolated output 2 high:
010900030432F00000
Write opto-isolated output 2 low:
010900030433F00000
Issue Pass beep
010900030477F00000
Issue Fail Beep
010900030479F00000