High Speed (Refrigerated) Micro-Centrifuge
15
CAUTION:
z
Load the rotor on the shaft to ensure rotor is in position until it contacts with the shaft,
and tighten the screw to connect firmly the rotor with shaft, otherwise the rotor maybe
move off to damage the centrifuge.
z
Should be confirmed the
rotor lid
is firmly tightened with rotor.
Load the rotor to the shaft to ensure rotor is in position until it fit well with the shaft.
You should feel a click when the rotor is properly loaded on the shaft. If not, may be something
stuck between the rotor and the shaft. Double check and clean it if necessary.
Rotate the rotor slightly by your fingers to double check, if the rotor vibrates obviously, load the
rotor again.
Clockwise rotate the nut using the wrench to tighten the rotor with shaft firmly.
Close the
rotor lid,
clockwise rotate and firmly tighten the
cover
with
rotor
and ensure is in
position. Close the
door
and then start running.
The method of removing rotor is as same as the above mentioned by turning the screw
counterclockwise.
8.1.2 Set the operation parameters
Press the
button to select required parameters. The parameter can be modified when the
parameter is flashing. Clockwise rotate the parameter button
to increase parameter value.
counter-clockwise rotate the parameter button
to decrease parameter value. Parameter button
rotate
faster, parameter value increase faster. The minimum speed increment is 100 rpm, the minimum time
increment is 1 second.
（
1
）
Set the speed
Press the select button
, choose the speed unit rpm, showing the speed parameter.
While select speed button, the speed symbol will flash into the speed parameter input
status.
The minimum speed value you can set 200rpm, the minimum increment is 10rpm.
Clockwise rotate parameter button
to increase parameter value. counter-clockwise
rotate parameter button
to decrease parameter value.
You can quick set value by parameter button
, quickly rotate parameter button
to
