DK2 AC02G, Руководство пользователя

Страница: 16 / 52

16 | AC02G(X) man.
BREAK-IN PROCEDURE
CAUTION! Do not attach air chuck or other tool to open end of hose until start-up has been
completed and unit checks okay.
NOTICE! Do not operate the compressor before reading instructions or damage may
result. (Refer to Fig.2 and Fig.3)
1. Turn regulator (Fig.3) fully clockwise
to open airflow.
2. Turn switch (Fig.2) to OFF position
and plug in power cord.
3. Turn switch (Fig.2) to ON position
and run unit for 30 minutes to break
in the pump parts.
4. Turn regulator knob (Fig.3) fully
counter-clockwise. Compressor will
build to maximum preset pressure
and shut off.
5. Turn regulator knob (Fig.3) clockwise
to cause air to bleed off. Compressor
will restart at a preset pressure.
6. Turn regulator knob (Fig.3) counter-
clockwise to shut off the air and turn
switch to off position.
7. Attach chuck or other tool to open
end of hose. Turn the regulator (Fig.3) on. With the switch (Fig.2) in the ON position,
the compressor pumps air into the tank. It shuts off automatically when unit reaches
its maximum preset pressure. In the OFF position, the pressure switch cannot function
and the compressor will not operate. Make sure switch (Fig.2) is in OFF position when
connecting or disconnecting power cord from electrical outlet.
NOTICE! MOISTURE IN COMPRESSED AIR: Moisture in compressed air will form into
droplets as it comes from an air compressor pump. When humidity is high or when a
compressor is in continuous use for an extended period of time, this moisture will collect
in the tank. When using a paint spray or sandblast gun, this water will be carried from the
tank through the hose, and out of the gun as droplets mixed with the spray material. This
condensation will cause water spots in a paint job, especially when spraying other than
water based paints. If sandblasting, it will cause the sand to case and clog the gun rendering
it ineffective. A filter in the air line (MP3105), located as near to the gun as possible, will help
eliminate this moisture.
FIGURE 2: PRESSURE SWITCH / INTERRUPTEUR DE PRESSION
SWITCH HANDLE
POIGNÉE DE L’INTERRUPTEUR
OFF
ON
ENGLISH