djpower TOPCAT H-X3 DMX, Руководство пользователя

Страница: 11 / 12

- 10 -
4.4.1 DMX Working Page
Standby and
setup page
DMX Address
1 Pressing “▲”or “▼“ to set the DMX starting address 1 - 512
When setting the DMX starting address, the number of channels occupied by the DMX mode
must be considered. If the starting address is too high, some channels may not be controlled.
In DMX mode, each machine responds to the control of the DMX controller through its own
unique starting address. Machines with the same starting address will be synchronized accordingly.
When connected with DMX controller and receiving DMX signal, the LCD display will always
show current DMX starting address which can be reset by pressing “▲”or “▼“.
4.4.2 DMX Channel Assignments and Values
H-X3 DMX has 1 DMX channel and can be connected by 3-pin or 5-pin DMX sockets. Set the DMX start address within the range
of 001-512, you can independently control 512pcs devices with one DMX channel.
Channel
Function Value Description
1
Fog Output
0-10 OFF
11-255 Increase gradually
5 TECHNICAL INFORMATION
5.1 Maintenance
H-X3 DMX needs regular maintenance to achieve the best performance.
However, in order to achieve the best results, some cleaning and maintenance
steps are essential:
• After use, disconnect all power to the unit, please wait till the water at a safe
temperature of 86°F (30°C) or below.
• Please open the drain valve located at the base of the unit to drain the
remaining water.
5.2 Storage
Before storing the machine, clean it and empty the fluid tank.
Test and run your H-X3 DMX every month to achieve the best performance.