dji Zenmuse H3-3D, Руководство пользователя

Страница: 16 / 18

16
©
2014 DJI. All Rights Reserved.
Appendix
Troubleshooting
Problem Cause Solution
Gimbal keeps drifting
after initialization.
1. The transmitter trims value is
beyond the acceptable limit.
2. The GCU is disconnected from the
flight control system.
3. The gimbal is not mounted correctly.
1. Adju
st the transmitter trims value.
2. Connect the GCU and flight control
system.
3. Ensure the gimbal is mounted so it
is parallel with the aircraft, and the
camera is
pointing towards the nose.
The gimbal axes are
not level.
Factory calibration error.
Contact your local dealer or DJI
customer service for assistance.
Unable to determine
gimbal orientation.
BVR (beyond visual range) flight.
Use a wireless video transmission
module.
Settings When Using the A2 Flight Control System
Users should configure the H3-3D’s pitch control in the A2 assistant when using the A2 Flight
Control System. Map the H3-3D to two channels on the transmitter as shown in the following
diagram. DJI recommends the use of a knob switch or a stick with spring back function for tilt
control, and a 2-position switch for MODE.
Zenmuse Channels
REV
0
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
ROLL
REV
0
PAN
REV
0
TILT
REV 0 MODE
REV 0 SHUT
REV 0 AUX1
REV
0
AUX2
REV
0
AUX3
Appendix