©2013 DJI Innovations. All Rights Reserved.
Assistant Software Installation and Configuration
Step1 Software and Driver Installation on a PC
1.
Please download the drive installer and the assistant software installer from DJI website
“www.dji-innovations.com”, by selecting the Download web page of corresponding product.
2.
Switch on the transmitter first, and then power on the autopilot system.
3.
Connect the autopilot system and the PC via a Micro-USB cable, and power on the autopilot system.
4.
Run the driver installer, and follow the instructions strictly to finish installation.
5.
Run the assistant software installer, and follow the instructions strictly to finish installation.
Step2
Configuration by Assistant Software on a PC
1.
Power on the PC. Make sure your computer is connected to the Internet for the first time you use.
2.
Switch on the transmitter first, and then power on the autopilot system. Connect the autopilot system to
the PC with a Micro-USB cable. DO NOT break the connection until setup is finished.
3.
Run the Assistant Software.
4.
Observe the indicators on the left bottom of the software. (
They are the connection indicator and
communication indicator in order.) If the communication indicator is blinking, that the software is ready,
please go to next step.
5.
Select the “Info” option. Check the software firmware version. If the upgrade is available, you may update
the assistant software.
6.
Select the “Upgrade” option. Check the Main Controller, GPS and IMU firmware version.
7.
Select the “Basic” option. Please follow step-by-step for your first-time-configuration. Basic configuration
is necessary, including Mixer Type, Mounting, RC, and Gain settings.
8.
You can click the “Advanced” option for more parameter settings. Advanced setting is optional. There are
settings of Motor, FailSafe, Intelligent Orientation Control (IOC), Gimbal, Low-Voltage Alert, and Flight
Limits. Read the instruction in the assistant software to obtain more details.
9.
Select the “Viewer” option to check all parameters.
10.
Then break the Micro-USB cable, power off the aircraft. Finished.
(1)
You may be required to fill register information for your first-time-usage.
(2)
If the communication indicator is blue on, please double check the connections.
(3)
Basic configuration is necessary before you go to the “Basic Flying Test”.
(4)
Users are required to install a Windows system, since the software can only run on Windows
system .
(1)
If the firmware upgrade is available, please upgrade it by referring to the Firmware Upgrade
in the Appendix.
(2)
This step is required to use together with the assistant software to obtain more details.