42
43
1.
If your child restraint is not held securely
by the belt:
Press down firmly on the child restraint and remove all the
slack in the belt. Make sure the belt buckle is not up against
the child restraint where the belt cannot be tightened.
Review Locking Clip section and Top Anchorage Strap
Section. If you cannot secure the child restraint tightly,
move it to another seating location.
2.
If the child restraint buckle or harness release
lever sticks or you cannot get the straps tight
enough around child:
DO NOT LUBRICATE. Check around buckle and harness
adjustment lever for dropped food, sticky spilled drinks, dirt,
leaves, etc. Clean with warm water and/or remove object
with tweezers. If you cannot get the harness to adjust and
remain tight with the buckle securely locked, do not use the
child restraint.
3.
If your harness twists or ropes:
Straighten the harness each time you put your child in the
seat to help prevent twisting. Lock the buckle and tighten
harness and it will be ready for next use.
4.
In belt-positioning mode, if your child restraint is
not held securely by the vehicle belt:
Remove all the slack in the vehicle belt. Make sure the belt
buckle is not up against the child restraint where the belt
cannot be tightened. If you cannot secure the child restraint
tightly, move it to another seating location.
5.
In belt-positioning mode, if the shoulder belt
crosses the child’s neck when using the child
restraint:
Try moving the child restraint toward the center of vehicle
or move the vehicle seat forward or back. Check to see if
your vehicle has adjustable shoulder belt anchor points. Do
Not place the shoulder belt behind the child.
Troubleshooting
Installation Tips:
When using the internal harness system, the harness must
be positioned at or above the child’s shoulders.
When using the internal harness system, make sure the
vehicle lap belt is locked.When you grasp the child restraint
at the belt path, it should not move more than about an
inch side to side.
4358-3492D Singles 5/27/09 2:19 PM Page 45