15
7
Check Harness Height:
Determine which set of
harness slots works best
for your child. Adjust if
needed.
Rethread harness into new
harness slot location.
Make sure harness straps
do not twist.
11
Press red button on
buckle to release the
buckle plates. Pull buckle
plates out. Place harness
straps over sides of child
restraint.
5
6
Place the child’s bottom
and back flat against the
child restraint.This will
increase comfort and allow
the harness to properly
tighten.
Harness slot being used
must be
even with or
just below
the shoulders.
If the bottom harness slots
are above the child’s
shoulders,
do not
use this
child restraint until the
child grows into it.
Harness
Slot
8
14
continued on next page.
10
From the front of child
restraint, pull harness strap
out. Repeat for other
adjustment bracket.
To change harness
location:
From the back of the child
restraint, remove free end
of harness from harness
adjustment bracket.
9
Rethread one harness end
onto one adjustment
bracket by threading loose
end over lower bar, behind
locking teeth and up
between upper teeth and
top of bracket. Thread
harness end between
locking teeth and out the
bottom of bracket as
shown. Make sure harness
does not twist. Repeat for
other adjustment bracket.
12
WARNING
!
Failure to reinstall the harness system correctly
can result in serious injury or death.
4358-3394G Designer USA 10/23/06 4:16 PM Page 17
