With weakest hand at belt
path, tilt and push the base
forward and back, and
from side to side. If the
seat belts do not loosen,
your child restraint should
be secure.
NOTE:
Some “play” from
front to back or about an
inch from side to side is
acceptable. If it moves more, review “Knowing Your
Vehicle Belts” and “The Locking Clip” sections.
29
6
With child secured in
child restraint, attach to
base. Align notches in
the front of shell with
the bars on the base.
Push down firmly to lock
into place. You will hear
a “click” when it is
locked. Pull up to make
sure it is locked into
place.
28
4
Push down firmly on the
base and pull up on the
belt to tighten. For a
manual belt, refer to
“Knowing Your Vehicle
Belts” section. Pull up on
shoulder strap to
remove any slack.
5
WARNING
!
Using this child restraint in any vehicle
seat where the lap belt cannot be
tightened securely and properly or where
it can be loosened by pulling on it can
result in serious injury or death.
Rear
-Facing Use:
5-22 lbs (2.3-10 kg),
19-29” (48-74 cm).
continued on next page.
A loose LATCH system can result in
serious injury or death.
When LATCH is not
available, fasten belt hooks
together in front of base
as shown.
WARNING:
!
Rear-Facing Installation with
Vehicle Belt - Using the Base:
1
Place base in the back seat
with taller side against the
back of vehicle seat.
2
Thread the vehicle lap or
lap/shoulder belt
combination through belt
path as shown. Buckle
vehicle belt.
3
4358-3394G Designer USA 10/23/06 4:16 PM Page 31
