18
19
Removing Seat Pad for Cleaning
1
2
If your child restraint has
armrests, pull armrest
covers off armrests and
pull through hole in back
of shell.
Turn shell over to expose
the back of the child
restraint. Release the
elastic straps shown in
red. Pull pad off shell.
Clean with warm sudsy
water, rinse clean and air
dry. Do not use bleach or
other harsh cleaners.
To replace pad, refer to
“Preparing Child
Restraint” section.
Troubleshooting
1.
If your child restraint is not held securely
by the vehicle belt:
Remove all the slack in the vehicle belt. Make sure the belt
buckle is not up against the child restraint where the belt
cannot be tightened. If you cannot secure the child restraint
tightly, move it to another seating location.
2.
If the shoulder belt crosses the child’s neck
when using the child restraint:
Try moving the child restraint toward the center of vehicle
or move the vehicle seat forward or back. Check to see if
your vehicle has adjustable shoulder belt anchor points. Do
Not place the shoulder belt behind the child.
WARNING
!
Do not use this child restraint without the
seat pad. Failure to do this can result in
serious injury.
4358-4153 VoyagerVista Eng 8/21/06 2:32 PM Page 21
