23. RELOOP BUTTON
– If a SEAMLESS LOOP has been made, but the Player is not actively in SEAMLESS
LOOP mode (a loop is not playing), pressing the RELOOP BUTTON will instantly reactivate the
SEAMLESS LOOP mode. To exit loop, press the OUT BUTTON. LOOP and RELOOP will appear in the
LCD DISPLAY when the RELOOP function is available.
24. MASTER VOLUME CONTROL
– This knob is used to control the master output level. To avoid speaker
damage that may be caused by excessive volume, be sure this knob is always set to the lowest level
before turning the unit on(only available when MIXER OUTPUT is ON).
25. SD CARD SLOTS
– These are the SD slots where you insert your SD cards. One card per slot. Gently
insert your SD Card into the slot. To eject your card, put the Media Operator in pause mode, and then
press the SD Card gently. The SD Card should "Pop" out. The preferred file format is Mp3.
26. USB PORT
– This is the USB port where you insert your USB mass storage device for playing MP3 files.
27. MICROPHONE VOLUME CONTROL
– This knob controls the output volume of the MICROPHONE (only
available when MIXER OUTPUT is ON).
28. INPUT FADER
(Channel Fader)
– These faders are used to control the output signal of any source assigned
to its particular player (only available when MIXER OUTPUT is ON).
29. PITCH SLIDER
– This slider is used to adjust the playback pitch percentage. The slider is a set adjustment
and will remain set until the pitch slider is move or the pitch function has been turned off.
This adjustment
can be made with or without a music source device (USB stick or SD card) in the player. The pitch
adjustment will remain even if a music source device (USB stick or SD card) has been removed and will
reflect on any other music source device inserted into the player. That is to say, if you set a +2% pitch on
one music source device, remove that device and insert another, that music source device too will have a
+2% pitch. The amount of pitch
being applied will be displayed in the LCD.
30. LCD DISPLAY
– This high quality LCD display indicates all the functions, as they are occurring. This
display is viewable at several comfortable angles.
31. AUDIO OUTPUTS
– AUDIO OUTPUT from player 2: Output for the audio signal from player 2. Use the
supplied RCA phono cables to connect these outputs to the CD/line input of an external mixing unit.
32. CONTROL START sockets
– This remote control is only compatible with certain mixers. If you are using a
mixer with fader start function, use this connector to plug into your fader start compatible mixer.
Attention: Please note that these sockets must never be connected with any voltage.
33. POWER CONNECTOR
– Plug in the included power adapter here. Please use only the supplied power
adaptor or a DC6V 2.0A
.
34. AUDIO OUTPUT from player 1 or mixer
–Output depending on the setting of the
MIXER OUTPUT MODE
.
35. BALANCED OUTPUTS JACKS
–These 1/4” (6.3 mm) TRS jacks for connecting an amplifier provide a
balanced line level output.
36. MICROPHONE
– This jack is used to connect a microphone to the device. The volume output level for this
microphone will be controlled by its own respective volume knob.
CONTROLS AND FUNCTIONS
TOP PANEL
CONTROLS AND FUNCTIONS
REAR PANEL
34
36
31
33
35
32
5
Содержание UI Station
Страница 1: ...Dual SD Card and USB MP3 Player with built in Mixer USER MANUAL ...
Страница 20: ......
