10.
• Check your FLIR Lepton version: Lepton2.0 (80x60, non-radiometric), Lepton2.5
(80x60, radiometric), Lepton3.0 (160x120, non-radiometric) and skip this step 10 if
you have the Lepton2.5
• Catch the MLX90614 single-point infrared sensor and plug it into the board, make
sure the little indicator matches the mark on the PCB
• Solder one pin first on the backside, then push the sensor against the board while
heating the solder on the same pin to make sure that the sensor is really soldered
flat to the board
• Solder the remaining three pins on the backside
• Cut the pins short with a cutting pliers
DIY-Thermocam V2 Assembly Guide
Page 10
DIY-Thermocam V2 Assembly Guide
