Dixie Chopper 38131503, Руководство оператора

Страница: 14 / 30

2-11 Hose Clamp Preparation
Note: To prevent injury, wear safety gear when
cutting or grinding hose clamps.
The hose clamps P#(J1000), provided with
your collection system, will fit hose sizes 6”
through 9”. The excess should be cut from the
clamp prior to installing the hoses. Follow the
steps listed to properly install the hose clamps
to your collection system.
Step 1: Measure from hose clamp’s fastening
end (end with tension screw) to the dimension
specified for your hose diameter and mark the
clamp for cutting. Refer to Figure 2-11a.
Step 2: See note on Caution above! Cut the
hose clamp at mark determined from Step 1. It
is recommended to use heavy-duty snips or a
cutting wheel. Refer to Figure 2-11b and 2-11c.
Step 3: Using a flat file or disc grinder, remove
sharp edges from clamp cut in Step 2. Refer to
Figure 2-11d.
Step 4: Loop previously cut hose clamp end
under and through the clamp’s tension screw.
Next, slide one finishing cap P#(V0040) over
cut end. Refer to Figure 2-11e.
Step 5: To clamp hose, first slide completed
clamp assembly over hose end. Next, hold
tension screw up while pulling clamp end to
pre-tighten. Then, fold tension screw down
and tighten using 5/16” socket or flat-head
screw driver. See Figure 2-11f.
!
CAUTION
6” Hose - Cut to 23”
7” Hose - Cut to 26”
8” Hose - Cut to 29”
9” Hose - Cut to 32”
Tension
Screw
Mark
Clamp
Here
Figure 2-11a
Figure 2-11b Figure 2-11c
Or Use Cutting Wheel Use Heavy-Duty Snips
Cut At
Mark
Cut At
Mark
Figure 2-11d
Remove Sharp Edge
From Hose Clamp
Figure 2-11e
Attach Finishing Cap
To Hose Clamp End
Figure 2-11f
Attach Hose
Tighten Clamp
14