dixell PROG TOOL, Руководство пользователя

Страница: 18 / 26

1592010401 v2.7 17/10/2008
PROG TOOL KIT
18
The first operation to do is to select the communication port of the
PC the PROG TOOL is connected to.
In the menu bar click on "Instruments" then on "serial COM". then
select the serial com port.
NOTE: reading and/or writing of parameters is possible only with
those controllers equipped with RS485 or TTL serial communication
port. For the instruments not equipped with serial port (PRIME
series and WING BASIC series) only the creation of HOT KEY is
allowed
3.3.1 HOW TO READ PARAMETERS FROM A CONTROLLER
To read the parameters map of a instrument connected to PROG
TOOL proceed as follows:
First of all check that the model and the software version of the
instrument are included in the table of compatibility present at
appendix “A” of this manual (page
Errore. Il segnalibro non è
definito. ).
Then connect the instrument to PROG TOOL following the
instructions of the paragraph 2.5 (page 9).
Click on the icon
(open map from device) on the icon bar or
select “Read Device” from menu “File” in the menu bar.
the PROG TOOL will start to read the parameter map of the
controller, at the end operation it will be possible to modify the
values of the parameters as described at page 21 in the paragraph