Divus OPENDOOR, Руководство пользователя

Страница: 89 / 111

DIVUS OPENDOOR manual 89
Sensibility
Specifies the range for the motion detection. By rotating the potentiometer in clockwise direction the sensibility
is increased, where values from 3 to 12 meters are possible. The range will only have affect if the twilight sensor
has enabled the relay contact.
LED „Active“
Fast blinking of this LED it means that the OD-Presence is restarting.
Periodic blinking of this LED it means, that OD-Presence is ready (normal function).
If the LED is still on, it means that motion has been detected and the relay contact is closed.
If this LED is switched off and switched on again fast, during it is still on, it means that another motion was de-
tected and the time delay starts again (Re-trigger).
LED „Motion“
This LED lights up, when motion is detected.
LED „Twi-Light“
This LED stays on, when the twilight sensors detects lesser brightness than configured with the potentiometer
„Light“.
Jumper 1 „Re-trigger“
If this jumper is set, the OD-Presence will re-trigger the time delay every time another motion is detected. If this
jumper is removed, the OD-Presence will close the relay contact for the defined time delay when a motion is
detected and open the relay contact again, after the time delay is over; if the OD-Presence detects other motion
while the time delay is running it will have no effect.
Jumper 2 „Testmode light“
If this jumper is set in the test mode for testing the setting of the „Light“ potentiometer is activated; the settings
of the “Light” potentiometer takes effect after 3-5 seconds. If this jumper is removed, changing the setting of
the “Light” potentiometer will take about 30 minutes to take effect.