46
Attach squeegee
Filling water
Dosage:
Only use chemical products recommended for the scrubber dryer by the
manufacturer.
Dosing examples (the concentration is product-dependent):
Dosing variants:
Start of operation
Manual setting of the functions when using for the first time
• Remount the brush holder and lock it.
• Place the squeegee on the floor in front of the
machine.
• Incline the machine to the rear and run over the
squeegee.
• Set the machine on the floor again.
• Place the locking nut in the slot provided.
• Turn the locking nut through 90°.
Caution:
Maximum permissible water temperature 60 °C/140 °F.
• Switch the machine off.
• Remove the rubber cap from the solution tank.
• Fill the solution tank with water up to the
maximum filling level.
• Replace the rubber cap on the solution tank.
Caution:
Wear protective gloves, goggles and the corresponding
(protective) work clothing when handling chemical products!
Caution:
The use of other products (e.g. products containing chlorine)
could damage or destroy the machine.
Instructions on the product’s
packaging
Tank capacity
Product amount
per tank filling
0.25%
25ml to 10l water 10l
25ml = 0.25l
2
1
10L
0.5%
50ml to 10l water 10l
50ml = 0.5l
• Add the product measured with the dosing cup to the water in the solution
tank.
• The TASKI J-Flex dosing system or the QFM dosing station can also be
used for simplified and quicker dosing.
Please contact your TASKI partner for further information about these
systems.
Caution:
Always wear non-slip shoes and appropriate work clothing while
working with this machine!
• Bring the machine into the working position by
swivelling the parking support up.
• Pull the height adjustment lever on the machine
handle and slowly lower the central steel pillar
into a comfortable working position, making
sure your arms are almost straight.
• Release the height adjustment lever, and the central steel pillar will then lock
into place.
• Switch the machine on. To do this, hold down
the ON/OFF button (main switch) for 3 seconds.
• The cleaning solution button is automatically
pre-selected.
(See page 47: When switching on again)
• Press the suction unit button.
The indicators light up briefly.
• Adjust the water quantity with the volume
regulation.
1. low: for smooth surfaces, raised
2. medium: for smooth surfaces, free areas
3. high level: indirect cleaning and heavily
soiled areas
• Pull the operating lever.
By doing this the tool is activated.
Instructions on the product’s
packaging
Tank capacity
Product amount
per tank filling
1
2
3