Dive Perfect Stubby LED-1500 User Manual
Rev 1.1, 18-Jun-2014
Page
2
of
4
•
Output:
1500 Lumens
•
Colour Temperature:
6000-7000K
•
Materials:
T-6061-T6 durable aluminium alloy,
anti-corrosive anodised housing, copper cylinder switch,
upset glass lens
•
Batteries:
Three (3) 1.5 V “AA” size (double A) Alkaline batteries
•
Maximum Operating Depth:
200 metres / 656 feet waterproof (IP 88 waterproof standard)
Three layers of O-ring seals for the Rotary switch on middle body
•
Modes:
ON or OFF
•
Dimensions:
Length: 130 mm, Head Diameter: 51 mm,
Middle Diameter: 40 mm; Tail Diameter: 42 mm
•
Weight:
350 grams / 0.77 lbs (excluding batteries)
Note: Dive Perfect reserves the right to change product specifications without notice.
3. How to use:
The Dive Perfect Stubby LED-1500 Dive Light
has a simple operating procedure. Once the
batteries are installed into the supplied battery
carrier, slide the battery carrier pack into the
housing and secure the light head by turning the
housing into the light head clockwise until it stops
— at this point the light is in the “ON” position.
(The light will activate shortly before reaching the
fully “ON” position.) To deactivate light: Turn the
cap counter-clockwise until the light goes “OFF”.
(1)
Battery Removal.
Unscrew the light head
cap from the dive light body and remove the
battery carrier. Please pay attention to the
positive and negative battery orientation.
(2)
Battery Installation.
Put three (3) “AA” size
Alkaline batteries into the battery carrier.
Please note that one battery is oriented
differently to the other two batteries. Refer to
the markings on the battery carrier if you’re
unsure as to which way they go.
(3)
Carrier installation.
Put the battery carrier
back into the torch body with the negative
end towards the bottom and the positive end
towards where the light head cap screws on.
(4)
Clockwise tighten the light head cap until
the light is ON.
The light turns OFF when
you reverse direction, unscrewing the light
head cap counter-clockwise. It’s oaky to turn
the dive light ON and OFF when underwater,
but please do not screw counter-clockwise
too much or you will flood the dive light!
(5)
Storage.
Please take out the battery carrier
pack when the dive light will be stored for a
long time.
4. Batteries
LEDs require proper battery polarity to function. If
the unit fails to operate, check the battery
orientation and battery carrier orientation.
For best performance, use Alkaline “AA” 1.5 V
battery cells. Zinc-Carbon, Nickel-Cadmium
(NiCd) and Nickel-Metal-Hydride (NiMH) batteries
may be used but will result in reduced brightness
and/or burn time.
WARNING:
•
Never mix fresh and used batteries.
•
Never mix different battery brands or
chemistry types.
•
Always remove drained batteries immediately.
NOTE:
Lithium batteries offer extended constant
brightness time, extreme cold weather
performance, and lighter weight. Rechargeable
NiCd or NiMH batteries may result in reduced
brightness due to lower nominal voltage.
NOTE:
Some battery types can emit hydrogen
gas, which can create an explosive potential in
sealed devices if it is not vented or removed.
