Dive Gear Express DGX Gears XTRA Regulator, Руководство по обслуживанию

Страница: 20 / 26

6. Reverse the tool to hold the stack and protect the Piston end ­ Fig. 39. Insert the Piston/End Cap/Port
Swivel assembly into the regulator and screw it on hand tight ­ Fig. 40.
Fig. 39 Fig. 40
7. Install the 1
st
stage handle into a high­pressure port ­ Fig. 41. Use the Multi­Tool to tighten the End Cap/Port
Swivel assembly to the body. A piece of rubber may be used to lessen the chance of scratching the End Cap
­ Fig. 42. Tighten the connection so that no gap is visible, and the connection is secure. There is no torque
specification for this.
Fig. 41 Fig. 42
8. Set the assembly aside and install the O­ring (30) in the HP side of the body, as shown using the blunt brass
or plastic pick ­ Fig. 43. Install the O­ring (32) onto the HP Seat Retainer and place the HP seat (31) into the
HP Seat Retainer. Orient the seat with the concave side towards the Piston and the flat side facing the HP
Seat Retainer ­ Fig. 44.
Fig. 43 Fig. 44