IDEAL
-
P
KOSMOS SERIE
www.ditel.es
12
8 8 8 8
Pro
dAtA
InP
dSP
SEt
AnA
INPUT CONFIGURATION
When connecting instrument to Power supply, display test begins automatically to check the good function of LED
’
s
and digits, once this test is finished, display shows internal software version and then the unit goes to
RUN
mode.
Configuration software has a hierarchical structure composed of a number of menus and submenus. By pressing
ENTER
key, display shows
“
Pro
”,
a new pressing brings access to main menu where appear configuration menus,
that is, input configuration (
InP
), display configuration (
dSP
), setpoints configuration (
SEtP
) and analog output
configuration (
AnA
).
If configuration is totally locked
-
out, when pressing
ENTER
key to get into main menu, display shows
“
dAtA
”
instead of
“
Pro
”.
This indicates that it is only possible to see programmed information and that it is not allowed to
modifiy any parameter from the entire configuration. In this visualization mode, the instrument automatically
switches back to
RUN
mode after 15 seconds since last key press.
Configuration menu
The instrument provides 3 keys for progressing through the
menus and submenus and for data introducing/modifying:
ENTER
:
Vertical displacement / Validates data.
UP
:
Increases active digit value.
SHIFT/DOWN
:
Horizontal displacement /
Changes active digit / Decrements the display
value of the setpoint generator in 'diMM' mode.
Input configuration
The first menu corresponds to input configuration. This menu, in turn, consists of two submenus: process (
ProC
),
temperature (
tEMP
).
Once inside each menu, all configuration parameters are sequentially shown and they can then be introduced or
edited by pressing
ENTER
key. Numeric values must be entered digit by digit, first selecting digit and then
changing its value. When the display reach desired value, a new
ENTER
key pressing validates data and routine
goes forward to next configuration step.
Data entered or changes made during configuration are stored in device memory only when programmation
routine belonging to the respective submenu is completed, not before. On last routine step and after having
pressed
ENTER
key, display indicates
“
StorE
”
and the unit goes back again to
RUN
mode.
MENÚ PRINCIPAL
InP
ProC
tEMP
