13
IP2352EN
EN
6.5 Adjusting the mechanical end stop (standard on PWR50AC)
Bring the gate wing to its fully open position. Loosen the mechanical end stop with a 5mm Allen
wrench, just enough so that it can slide along the drive screw. Move it up against the split nut and
and clamp them in place with a 5mm Allen wrench so fix the 3mm socket set screw.
6.6 Adjusting electromechanical limit switch (optional)
Bring the gate wing to its fully open or closed position. Loosen the limit switches with a Phillips
screwdriver, just enough so that they can slide along the guide, then bring them above the split
nut [14] until the sensor is activated. Fix them in place.
3mm
5mm
