14
CROSS5-7-8 - IP1747
GB
4. ELECTRICAL CONNECTION
Electrical wiring and starting are shown in the installation
manual of control panel E1-E1A (Cross5E-7E-8E) and 73RG
(Cross7EH).
230 V cables (power supply, flashing light and external courtesy
light, if any) are to be positioned on the right of the electric control
panel, as it is shown in the figure.
24 V cables (safeties, controls and external antenna, if any) are
to be positioned on the left of the electric control panel, as it is
shown in the figure.
ATTENTION: Connect the yellow-green ground cable to the
clamp already connected to the motor, as it is shown in the figure.
5. INSTALLING THE PHOTOCELLS INSIDE THE
GEARED MOTOR (fig. 4)
Additional photocells may be installed inside the gearmotor for
the protection of both opening and closing movement. Fit a re-
ceiver (RX) or a transmitter (TX) on the [U] brackets provided.
Installation of the photocells must be carried out in observance
of the standards EN 12453 and EN 12445.
Attention: the photocell receiver (RX) and transmitter (TX) may
also be installed at two different heights, the maximum permis-
sible difference in height being 300 mm.
6. INSTALLING LUXK7 INSIDE THE GEARED
MOTOR (fig. 5)
The courtesy lamp can be mounted inside the gear motor. For
mounting and connection, carry out the operations shown in
the figure.
ATTENTION: Connect the yellow-green ground cable to the
clamp already connected to the motor, as it is shown in the
figure.
The courtesy lamp can be enabled or disabled by means of a
BixLP4 radio remote control and by storing the CH3 function
(see instructions E1A, 73RG).
7. BATK7 [17] BATTERY KIT INSTALLATION
(only Cross7EH)
The BATK7 battery kit permits to operate the gate even in case
of mains power failure.
Note: when not in use, batteries are kept charged by means of
the control circuit.
Fit the batteries inside the geared motor and secure by means of
the appropriate support brackets (see instructions of BatK7).
8. MAINTENANCE PROGRAM (each 6 month)
Power off and geared motor released (see OPERATING IN-
STRUCTIONS):
- Visually check that the gate, anchoring bracket and existing
structure are sufficiently sturdy and in good condition.
- Check gate/gearmotor alignment and the distance (2-3 mm)
between the mouth of the pinion and the crest of the rack and
check the distance from the rack to the rack guide bracket
(3 mm), if fitted.
- Clean the wheel sliding tracks, lightly lubricate the pinion,
the rack or the chain. Manually move gate to check that it
slides freely and smoothly.
Power on and geared motor lock (see OPERATING INSTRUC-
TIONS):
- Check the functioning of the limit switches (the gate must
come to a halt about 20 mm before the stops).
- Check the power adjustments.
- Check the operation of all controls and safety functions.
ATTENTION: For spare parts, see the spares price list.
230
V
24 V
All right reserved
All data and specifications have been drawn up and checked
with the greatest care. The manufacturer cannot however take
any responsibility for eventual errors, ommisions or incomplete
data due to technical or illustrative purposes.
