1
1
3
2
Adjust upper and lower poles
Locate the spring plungers inside the bottom grommet hole of pole
B1
(If your unit has
B3
cross bar pre-installed remove prior). Starting
with the right side pole
B2
, push the spring plunger down and pull
B2
up slightly and twist it slightly so that the spring plunger remains
Repeat the same steps for the left side pole
B2
but use your
right foot for stability instead. Align poles
B2
and lock the spring
Hold the poles
B1
&
B2
with your hands and use your left foot on
the cross bridge of
B1
for stability. Pull
B2
upward until you reach
your desired height. Twist
B2
so that the spring plunger locks into
B1
B1
B1
B2
B2
B2
B2
Spring
plunger
Spring
plunger
Lift pole assembly so that the part remains upright and the
cable management holes are facing toward you.
