DISPENSE-RITE
®
Model: SLR-2F-CSD
INSTALLATION & BAFFLE SELECTION INSTRUCTIONS
The cup dispenser is completely assembled but will require the proper size silicone rubber baffle be inserted once the
dispenser has been installed. A full sleeve of cups is recommended for dispenser installation and baffle selection.
The SLR-2F-CSD model is a single spring (light) model and is intended for use with paper, plastic or foam cups in
horizontal mounting positions. This model may also be used vertically with foam cups. If the dispenser will be used
in a vertical or angled position with paper or plastic cups a heavier spring (not included) must be ordered separately.
Diversified Metal Products, Inc.
2205 Carlson Drive • Northbrook, IL 60062 • (847) 753-9595 • fax (847) 753-9648
www.dispense-rite.com • [email protected]
Cut a 5-1/4” diameter hole into the desired
mounting surface.
Rotate the cover ring counterclockwise and
remove from the dispenser. Remove the
cardboard spacer insert and discard.
4. Drill four 9/64” pilot holes in the locations shown
below. Fasten the dispenser with the four #10
screws provided.
1
2
4
5 "
132 mm
3
16
5-1/4”
134 mm
3. Insert the dispenser into the mounting hole.
Align the “UP” mark to the top in a horizontal or
angled application and to the rear in a vertical
mounting application.
3
SECTION ONE - CUP DISPENSER INSTALLATION
