GB - 2
IMPORTANT SAFETY INSTRUCTIONS (CONTINUED)
FOR UK ONLY
For your own safety read following instructions carefully before attempting to connect this
CD Player to the mains.
Mains Supply 220V - 240V~ 50Hz - AC only
This unit is designed to operate on a 220V-240V~ 50Hz supply only. Connecting it to other
power sources may damage it. Ensure that the supply corresponds to the information on
the rating label on the rear panel of the unit.
This component system may be fitted with a non-rewireable plug. If it is necessary to
change the fuse in a non-rewireable plug the fuse over must be refitted. If the fuse cover
becomes lost or damaged, the plug must not be used until a replacement, available from
the manufacturer, is obtained. It is important that the colour of the replacement fuse cover
corresponds with the colour marking on the base of the plug.
If the plug needs to be changed because it is not suitable for your socket, or becomes
damaged, it should be cut off and an appropriate plug fitted following the wiring instructions
below. The plug must then be disposed of safely, as insertion into a 3A socket is likely to
cause an electrical hazard.
IMPORTANT
The wires in the mains plug should be connected as shown in the diagram.
The colours of the wires in the mains lead of the unit may not correspond with the coloured
markings identifying the terminals in your plug. Connect them as follows:-
The wire which is coloured blue must be connected
to the terminal which is marked with the letter ‘N’ or
coloured black.
The wire which is coloured brown must be connected
to the terminal which is marked with the letter ‘L’ or
coloured red.
There should be no connectin to the earth terminal of
your plug.
If a 3 Amp (BS363) Plug is used, a 3 Amp Fuse must
be fitted, or if any other type of Plug is used a 3 Amp or
5 Amp Fuse must be fitted, either in the Plug or Adaptor,
or on the Distribution Board.
TS500BE Woerlein.indd 2
2009/8/4 4:53:43 PM
