Clock Display
Volume Dial
Use the
Volume Dial
to adjust the volume of the radio and
stories. Please note that this also controls your alarm volume.
Setting the Alarm
• Press and hold the
Alarm Set Button
until the display
flashes.
• Press the
Forward
or
Reverse Button
to adjust the
display to the desired alarm time (hold to set more rapidly).
Make sure to set the correct AM or PM time. The PM
indicator appears to the lower right of the time display;
there is no AM indicator.
• Set the
Alarm Select Switch
to “Mater” to wake up to
Mater’s voice, set to “Radio” to wake to radio, and set to
“Off” to disable the alarm. Alarm is active when the
icon
appears on the display.
• Press the
Alarm Set Button
to confirm alarm setting.
Snooze and Alarm Reset
Press down on the
Story Button
OR the
Night Light Button
when the alarm sounds to snooze the alarm for 10 minutes.
Press the
Alarm Set Button
to stop a sounding alarm and
reset it to come on the next day at the same time.
Setting up the Radio
Untie the FM antenna and extend to its full length for best
reception. DO NOT STRIP, ALTER OR ATTACH TO OTHER
ANTENNAS.
Using the Radio
• Press the
Radio Button
to turn on the radio. If you want
the radio to turn off by itself, keep pressing the Radio Button
to cycle through 60, 45, 30, and 15 minute radio timer
settings which will appear on the display. If “On” is displayed,
the radio will stay on indefinitely. When the radio is in use,
the
icon appears on the display. Please note the radio
is FM only.
• While the radio is in use, press the
Forward
and
Reverse Buttons
to adjust the frequency. Holding those
buttons down will scan through frequencies more rapidly.
• Turn off the radio by pressing the
Radio Button
again.
The last radio frequency used will be remembered.
Story Button
Press the
Story Button
as needed to cycle to and play each
of the 2 built-in stories and to turn story mode OFF.
Night Light Button
The alarm clock has a night light with 7 color settings. Press
the
Night
Light Button
to cycle through these settings: Color
change (fades continuously through the 3 colors), green high,
green low, amber high, amber low, blue high, blue low and off.
Please note that there are only 4 color settings available when
the radio is turned on.
Connecting the AC Adapter
The included AC adapter must be used for proper clock operation
and should be connected by an adult.
• Plug the AC adapter cable into the DC adapter jack on the
back of the unit (near the rear license plate) and connect the
plug end into a working outlet that is not controlled by a wall
switch.
Remove Demo Tab
The unit has a demo tab for in-store demonstration purposes.
Make sure to remove this tab from the bottom of the unit. To do
so, gently pull on tab. Dispose of tab properly.
Installing/Replacing the Backup Batteries
This unit comes with 3 AA batteries already installed. These are
for in-store demonstration purposes only and should be replaced
when you get the product home. When the included AC adapter
is connected, the batteries will serve as battery backup in the
event of a power failure. The batteries should be replaced when
the low battery icon appears on the display
1. Using a Phillips screwdriver, open the battery compartment
door located on the bottom of the unit.
2. Insert 3 new AA (LR6) batteries in the battery compartment.
Make sure batteries match the + and – as indicated in the
battery compartment diagram.
3. Replace battery compartment door. Do not overtighten screw.
WARNING : DO NOT THROW BATTERIES AWAY WITH
HOUSEHOLD TRASH. PLEASE CONSULT LOCAL
REGULATIONS FOR PROPER BATTERY DISPOSAL.
For the Best Possible Performance
• We recommend the use of alkaline batteries for longer life.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
• Batteries are to be inserted with correct polarity.
• Remove exhausted batteries from the unit.
• Do not attempt to recharge non-rechargeable batteries.
• Remove the rechargeable batteries from the unit before
charging.
• The supply terminals are not to be short-circuited.
• Batteries should be removed if the item will not be used for an
extended period of time, such as a month or longer, to prevent
battery leakage or damage.
• Rechargeable batteries should only be charged under adult
supervision.
• Only batteries of the same or equivalent type recommended
are to be used.
Setting The Time
• Press and hold the
Time Set Button
until the display
flashes.
• Press
the
Forward
or
Reverse Button
to adjust the clock
to the current time (hold to set more rapidly). Make sure to
set the correct AM or PM time. The PM indicator appears to
the lower right of the time display; there is no AM indicator.
• Press
the
Time Set Button
to confirm time setting.
Right Side of Mater
Volume Dial
Alarm Select Switch
Reverse Button
Story Button
Forward Button
Radio Button
Alarm Set Button
Night Light Button
Time Set Button
MODEL: CR-325 INSTRUCTION MANUAL front
Size: 357W x 240H mm
DATE: June 14, 2011
MATERIAL: 100gsm white glossy paper
PRINTING: Black
Back View
Backup Battery Installation
Radio Icon
PM Indicator
Alarm Icon
Low Battery Icon
RESETRESET
TESTTEST
DC
Adapter
Jack
Demo Tab
