Page 13
Verify signal strength bar is green and locked
. Exit the
Installation Summary
screen and
display the
Point Dish
screen. Make sure the signal strength bar is green and locked for the
satellites.
Note
: You might not see signal from all satellites or proper LNBF identification until you take a
software download and run a check switch in steps 12 and 13.
Take a software download
. Exit the
Point Dish
screen and follow the onscreen instructions for
taking a receiver software download. Do not disturb the receiver during the process of downloading
software. If exiting the
Point Dish
screen does not start the download process, put the receiver into
standby mode for at least 20 minutes (on most receivers) to allow the receiver to take a software
download.
Run Check Switch
. Run
Check Switch
again and confirm reception for the satellites (see
Figures 13, 14, and 15).
Install additional receivers
. If installing an additional receiver, follow steps 7-13, pages 10-13.
Make sure the summary screen shows reception from the correct satellites.
Содержание D1000.4 EA
Страница 30: ...Notes...