4.
Connect harness 12-pin plug (See
. Fig.2
) to radio 12-pin connector
vacated in step 2.
5.
Connect black wire to ground (we recommend radio chassis)
6.
Red wire
on installation harness must be connected to a
12V
Accessory supply
in vehicle.
Warning:
Accessory (ACC) supply available on BROWN wire (Most
GM’s) under steering column or on climate control harness or in
driver side fuse panel.
Always use voltmeter to verify voltage and check for engine noise
prior to finalizing. Accessory power is active wh
en ignition is in “ACC”
or “
ON
“positions
Pairing
Pairing process varies among devices but the basic steps are the same.
This process is done upon initial install and may not have to be repeated.
1.
Turn Ignition and Radio “ON”
LED inside module peephole will flash (pairing mode)
2.
Go to device
Bluetooth Settings
3.
Select
Bluetooth
and turn on.
4.
Tap
Scan for devices
.
5.
Wait for Bluetooth name to appear and
select it.
(See images below)
LED inside module peephole will glow steady (paired)
Not retaining remote CD changer and/or XM Subscription
Retaining remote CD changer and/or XM Subscription
