Fig. 3
Ground wire to radio chassis
4.
Tap or connect Accessory RED wire to suitable 12V
Accessory supply
source in vehicle (e.g., fuse box etc.) Find suggestions below.
Suggested 12V accessory supply options:
1. In 968: Left foot well Fuse box at Row C, Fuse 1 (7.5A/15A)
2. In 987: Kick Panel Fuse box at
Row B, Fuse 9
(7.5A)
3.
Alternate:
Remove hand-brake cover, locate
orange wire.
(See
Fig. 4
)
To avoid battery drainage, ensure circuit to which you are connecting the
module 12V accessory wire is turning OFF with key prior to finalizing.
Voltmeter or test light recommended.
4. Tap
WHITE
wire (pin 12) on radio main Quadlock (See
Fig. 5
). This wire is
antenna/amp turn on which means it is controlled by radio ON/OFF button.
Fig. 4
below brake lever
Warning:
Do not connect accessory wire to 12V battery (always on)
supply. Use voltmeter or test light to verify voltage and engine noise
prior to finalizing install. In case of engine noise, we recommend adding
a noise filter such as our
Secure module and proceed to pairing
Fig. 5
Radio main plug
