DirecTV HIRD-E6, Руководство пользователя

Страница: 20 / 61

DIRECTV PARA TODOS™ SYSTEM FROM HUGHES - OWNER’S MANUAL
P
AGE
4-2
Confirm that you have all of the satellite dish antenna components. Refer to the Installation
Manual that comes with your DIRECTV PARA TODOS satellite dish antenna. If you are missing
any parts contact the Hughes Customer Care Center at 1-877-272-8636.
Your satellite dish antenna will need to be pointed at a satellite cluster located 22,300 miles in
orbit above the equator. To aim the satellite dish antenna at the satellites you need to know the
azimuth and elevation angles. The digital satellite receiver will assist you in determining these
angles based on your ZIP code. If you see the message:
“Searching for satellite signal. To access related utilities, press .”
press the key. Otherwise, press keys in the following order to navigate to the
INSTALLATION screen:
•
to display the MAIN MENU
•
or to move the highlight over the Setup Menu button
•
to display the SETUP MENU
•
or to move the highlight over the Installation button
•
to display the INSTALLATION screen
Determine Where to Point Your
Satellite Dish Antenna
The INSTALLATION screen
When you press you will see a screen that assists you with the satellite dish antenna
pointing and signal strength utilities.
Move the highlight to the Dish Type button and press . You
will need to specify the style of dish you have so that the pointing
information will be accurate. Press the or keys on the remote
control or receiver front panel until your preferred selection is
highlighted.
For the DIRECTV PARA TODOS™ System, the
Dish Type must be set to “DUAL.”
SINGLE – Refers to the traditional 18” satellite dish. This dish will
be configured with an LNB with either 1 or 2 outputs.
DUAL – Refers to the larger, oval, multi-LNB satellite dish. This
dish will be configured with two LNBs in the positions marked
“SAT A” (101
°
) and “SAT B” (119
°
). Each LNB will have 2
outputs.
TRIPLE - Refers to the larger, oval, multi-LNB satellite dish. This dish will be configured with
three LNBs in the positions marked “SAT A” (101
°
), “SAT B” (119
°
) and “SAT C” (110
°
).
Note: When “Satellite 1” is used in reference, this is equivalent to “SAT A.” Likewise,
“Satellite 2” equates to “SAT B” and “Satellite 3” equates to SAT C. Choosing the correct
dish type is necessary to obtain correct pointing results.
After highlighting the appropriate dish type, press .
Next, move the highlight to the Position button and press . You will need to determine
your location by either ZIP code or by your latitudinal and longitudinal position. Press the or
keys on the remote control or receiver front panel until your preferred selection is highlighted,
then press
.
The INSTALLATION screen